What Is RFID in Access Control?

RFID, or Radio Frequency Identification, is the technology behind most modern access cards, tags, and key fobs. It relies on wireless communication between a reader and a chip in the card, so that a user can identify themselves by holding the card up to a door reader without physical contact. The industry uses RFID in the vast majority of access control systems for offices, residential properties, and industrial sites.

The radio signal between card and reader

An RFID reader at the door emits a continuous radio field on a set frequency. When a compatible card or tag comes within range, the chip's antenna is activated and the chip sends its unique ID number back to the reader. The reader in turn passes the ID to a door controller, which checks it against a database of access rights and opens the door if the person is authorized at that moment.

The whole exchange takes less than a second and requires neither physical contact nor a battery in the card. That speed makes the technology practical in busy environments with a high flow of people, such as main entrances to office buildings or shared entrances in multifamily buildings.

Active and passive tags

RFID credentials fall into two main types, based on how they are powered.

Passive tags have no battery of their own. They draw energy from the reader's magnetic field and respond only when they are within the reader's range, which is anything from a few centimeters to a few tens of centimeters. Passive tags are cheap, small, and have a virtually unlimited lifespan. Cards, key fobs, and stickers used in access control are therefore almost always passive.

Active tags have an internal battery and can transmit information over several meters. They are used less often in access control and more often in industry, logistics, and vehicle identification, where read range matters. The drawbacks are limited battery life, higher cost, and a larger form factor.

Common RFID standards

Two technologies dominate the market, and the choice between them affects both security level and price.

EM at 125 kHz is the older standard and is still common in residential properties and older access control installations. The technology is cheap but has weak security properties. EM cards send their ID in plain text without encryption, which means they can easily be cloned using equipment that is available online for very little money.

MIFARE at 13.56 MHz is the modern standard for new installations. It comes in several variants: MIFARE Classic is widespread but has documented weaknesses, while MIFARE DESFire with AES encryption is the industry's current baseline for more secure environments. For organizations that manage sensitive areas or are subject to national security regulations, the DESFire level is normally the minimum.

Security and the risk of cloning

RFID security is an area that many condo and homeowners associations and smaller offices underestimate. A common scenario is that someone with the right equipment can clone an EM card simply by standing close to the cardholder for a short while in an elevator or at a lunch spot. The copy then works on every door the tag gives access to, without the original holder noticing anything.

There are several measures to consider to reduce the risk, each with a different cost and impact:

  • Migrate from EM 125 kHz to MIFARE DESFire when replacing readers or door controllers
  • Supplement cards with a PIN code or mobile verification on sensitive doors
  • Use mobile credentials via Bluetooth or NFC where security requirements are higher
  • Keep the list of access rights up to date and deactivate lost cards immediately
  • Enable access logs and review them regularly

Together, these measures raise the level of protection considerably compared with an older RFID system on its own, even if the whole infrastructure is not replaced at once.

Ways forward when upgrading

RFID technology has been the foundation of access control for decades, and few competitors stand ready to take over. A first survey should establish which frequencies and standards the existing readers support, since mixed installations need multi-frequency readers to work during a migration. Many modern readers support both 125 kHz and 13.56 MHz alongside mobile credentials via NFC and Bluetooth.

Organizations that are subject to national security regulations, or whose access logs process personal data, also need to factor cybersecurity into the decision. RFID traffic between reader and door controller should be encrypted using OSDP Secure Channel, and access control databases should be protected according to the same principles as other sensitive information. Documentation of the chosen standards, encryption levels, and card replacement procedures cannot be cut back without the technology losing value.