What is RFID in access control?
RFID, or Radio Frequency Identification, is the technology behind most modern access cards, tags and key fobs. It relies on wireless communication between a reader and a chip in the card, so that a user can identify themselves by holding the card up to a door reader without physical contact. The industry uses RFID in the vast majority of access control systems for offices, residential properties and industrial sites.
The radio signal between card and reader
An RFID reader at the door emits a continuous radio field on a set frequency. When a compatible card or tag comes within range, the chip's antenna is activated and the chip sends its unique ID number back to the reader. The reader in turn passes the ID to a door controller, which checks it against a database of access rights and opens the door if the person is authorised at that moment.
The whole exchange takes less than a second and requires neither physical contact nor a battery in the card. That speed makes the technology practical in busy environments with a high flow of people, such as main entrances to offices or shared entrances in apartment buildings.
Active and passive tags
RFID credentials fall into two main types, based on how they are powered.
Passive tags have no battery of their own. They draw energy from the reader's magnetic field and respond only when they are within the reader's range, which is anything from a few centimetres to a few tens of centimetres. Passive tags are cheap, small and have a virtually unlimited lifespan. Cards, key fobs and stickers used in access control are therefore almost always passive.
Active tags have an internal battery and can transmit information over several metres. They are used less often in access control and more often in industry, logistics and vehicle identification, where read range matters. The drawbacks are limited battery life, higher cost and a larger format.
Common RFID standards
Two technologies dominate the market, and the choice between them affects both security level and price.
EM at 125 kHz is the older standard and is still common in residential properties and older access control installations. The technology is cheap but has weak security properties. EM cards send their ID in plain text without encryption, which means they can easily be cloned using equipment that is available online for very little money.
MIFARE at 13.56 MHz is the modern standard for new installations. It comes in several variants: MIFARE Classic is widespread but has documented weaknesses, while MIFARE DESFire with AES encryption is the industry's current baseline for more secure environments. For organisations that manage sensitive areas or are subject to national protective security legislation, the DESFire level is normally the minimum.
Security and the risk of cloning
RFID security is an area that many residents' associations and smaller offices underestimate. A common scenario is that someone with the right equipment can clone an EM card simply by standing close to the cardholder for a short while in a lift or at a lunch restaurant. The copy then works on every door the tag gives access to, without the original holder noticing anything.
There are several measures to consider to reduce the risk, each with a different cost and impact:
- Migrate from EM 125 kHz to MIFARE DESFire when replacing readers or door controllers
- Supplement cards with a PIN code or mobile verification on sensitive doors
- Use mobile keys via Bluetooth or NFC where security requirements are higher
- Keep the list of access rights up to date and block lost cards immediately
- Enable access logs and review them regularly
Together, these measures raise the level of protection considerably compared with an older RFID system on its own, even if the whole infrastructure is not replaced at once.
Ways forward when upgrading
RFID technology has been the foundation of access control for decades, and few competitors stand ready to take over. A first survey should establish which frequencies and standards the existing readers support, since mixed installations need multi-frequency readers to work during a migration. Many modern readers support both 125 kHz and 13.56 MHz alongside mobile credentials via NFC and Bluetooth.
Organisations that are subject to protective security legislation, or whose access logs process personal data, also need to factor cybersecurity into the decision. RFID traffic between reader and door controller should be encrypted using OSDP Secure Channel, and access control databases should be protected according to the same principles as other sensitive information. Documentation of the chosen standards, encryption levels and card replacement procedures cannot be cut back without the technology losing value.









